CONNECT PROVER SIGNALS In this HowTo will be explained how prover signals should be connected. This depends on the Flow-X type and the prover setup. Flow-X/P Ball prover / Compact prover. Connect the flow pulse signals to the corresponding modules ...
PRINT A SNAPSHOT REPORT ON STARTUP IN FLOW-X This document describes how to generate a snapshot repot whenever the Flow-X flow computer starts up for any reason. Define a new Calculation group Define a new tag to latch the latest startup time Give ...
Security Files In Flow-Xpress users and passwords can be modified and added both in online mode (directly in the flow computer, also for multiple flow computers at once) and offline mode (in the loaded application file). Each user has a specific ...
When using the Modbus Slave protocol, a synchronization problem may occur while reading values from a device. This HowTo explains how to overcome this problem.
This How To explains how you can set up one or more flow computers when a ProLinx device for HART master is also present. The flow computer’s HART master protocol is acting such that the flow computer is either listening or an active sender. When two ...
Calibration Calibration can be done on two levels 1. I/O calibration Calibration of analog inputs, PT-100 inputs and analog outputs 2. Calibration of process inputs Loop calibration of any process input (temperature, pressure, density, viscosity, ...
The procedure to calibrate an analog output is based on a 4-20 mA meter. 1. Connect the mA meter in series with the load. 2. Go to the analog output calibration display. Display → Diagnostics, IO, <Module x>, Calibration, Analog outputs With x the ...
Ground wiring The Flow-X flow computer uses the following separate ground connections: one common ground for the power supply and the digital signals ('0 V') one isolated common ground for the analog inputs ('Analog input common') one isolated common ...
How to simulate proving with the Flow-X flow computer This How to instruction will provide an example of how to program the FlowX to simulate proving a meter. Most newer flow computers require live pulses and detector inputs to prove a meter. Wiring ...